The contents of this directory may be deleted if there is no pending HTTP request. Requirement: $CFG->tempdir is a directory that must be shared by all cluster nodes.
#Does netspot kit have separate cpt code code
Locking support is not required, if any code tries to use file locks in dataroot outside of cachedir or muc directory it is a bug. It must be very reliable, administrators cannot manipulate files directly there. This MUST be a shared directory where each cluster node is accessing the files directly. The dirroot should be always read only for apache process because otherwise built in add-on installation and plugin uninstallation would get the nodes out of sync. The simplest solution is to have the same directory structure on each cluster node and synchronise these during each upgrade. The reason is that some some low level code may use the dirroot value for cache invalidation. It does not need to point to the same shared directory though. It is strongly recommended that $CFG->dirroot (which is automatically set via realpath(config.php)) contains the same path on all nodes. Please note that it is not compatible with $CFG->loginhttps. It cannot be dynamic.Įnable if you have if your nodes are accessed via different URL. It must be the same on all nodes, it must be the public facing URL. Cluster headaches do occur when there is a lot of data in here, so our aim is to REDUCE dependence on shared caches as much as possible, technically it is not possible to have only local caches.Įach node in cluster may use local set of php files including config.php, these may be synchronised via git for example, rsync, etc.
These directories must be shared because Moodle code relies on that, all cluster nodes must see the same data there. Note that these last two often cause confusion. $CFG->cachedir must be a shared directory.Cluster node clocks must be synchronised with difference dataroot must be a shared directory.
#Does netspot kit have separate cpt code upgrade
13.2 Large in-house NFS backend VM upgrade.8 Language installation and customisations.4.1 Alternative component cache location.If you want to use the functions of the DHCP server, consult your network administrator and perform either of the following settings. This is because a different IP address from the one that has been used is assigned. If you specify the setting so that the IP address is automatically assigned to the printer by the functions of the DHCP server, the printer may not be able to print after you cycle the power of the printer.Because it takes approximately two minutes to check whether DHCP, BOOTP, and RARP are available, it is recommended that you set the unused protocol(s) to OFF.If you specify to use any one of DHCP, BOOTP, or RARP, the values obtained from those are displayed after restarting this printer (If the values have been specified previously, they overwrite the obtained ones).If you cannot obtain information from the servers of DHCP, BOOTP, and RARP, the values specified here are used. Even if you are using any one of DHCP, BOOTP, or RARP, specify the IP address, subnet mask, and gateway address.For example, if you want to use DHCP, you need the DHCP server (or daemon).
0 kommentar(er)
